Very first pipe on lathe.

Want to show you work to the world? Want a place to post photos of your work and solicit the opinions of those that have gone before you? Post your work here.
Post Reply
Bobostro61
Posts: 23
Joined: Wed Nov 14, 2012 10:13 pm
Location: Chicago, IL

Very first pipe on lathe.

Post by Bobostro61 »

Started my very first lathe made pipe today. 33 degrees outside so I figured I'd venture in to the garage for some lathe practice. Not a very good block, so its a good one to start with as you can see the bad spots. I couldn't believe the time savings. I'm sure an hour or more of sanding was saved in the 10 minutes it took me to get the block to this point. Took a few minutes to line it all up because it is a pre-bored kit. Used my Rockler Excelsior. No vibration at all while turning the pipe. I was quite surprised.

Image
Post Reply