I was asked to post a photo of my sanding/buffing station recently. While everything is not set up at present, the basic setup is evident. So, I became ambitious after tidying up the shop and thought I'd post photos of the whole setup, FWIW to you all. I've yet to get a central dust collection system and the buffing wheels (which will be mounted on the opposite side of the sanding motors where the drill press and the bandsaw are sitting in the photos) have yet to be mounted and wired. Otherwise, it is pretty much what I will be sticking with sans sandblasting.
Cheers,
Jeff
General Setup w/ Lathes and Sanding/Finishing Bench
![Image](http://img450.imageshack.us/img450/5704/newworkshop32uc.jpg)
Sanding Station (Eventually 4 buffing wheels will be mounted on the other side with the double-madrel setup discussed in another thread.)
![Image](http://img450.imageshack.us/img450/6580/newworkshop0kg.jpg)
"New" Old 12" Craftsman Bandsaw (and for $25, a steal!)
![Image](http://img322.imageshack.us/img322/9429/newworkshop16zy.jpg)
Sanding/Finishing Bench
![Image](http://img450.imageshack.us/img450/7530/newworkshop47nc.jpg)
Lathe #1 (the one that was knocked off its skid when shipped)--Eventually will be setup exclusively for turning.
![Image](http://img450.imageshack.us/img450/5918/newworkshop52pk.jpg)
Lathe #2, the workhorse, for drilling, stemwork, etc.
![Image](http://img450.imageshack.us/img450/1463/newworkshop64af.jpg)
Sanding wheel setup
![Image](http://img450.imageshack.us/img450/2236/newworkshop74ix.jpg)
New Shelving w/ briar and rod stock storage (a hell of a lot better than the cardboard boxes on the floor used in the past!)
![Image](http://img450.imageshack.us/img450/1364/newworkshop98rq.jpg)