Where

MilesW · Post by **MilesW** » Wed May 17, 2006 8:49 am

Can I find a source for pre formed stems? I just started and do not have the equipment to make stems as of yet. There is the problem I managed to break off the tenon on the stem of a pipe I was making from a pre bored block. the pipe is shaping up nicely. Need to buy another stem with out buying in bulk to get it? Any suggestions? Thanks

Miles

bvartist · Post by **bvartist** » Wed May 17, 2006 9:34 am

Miles, heres a couple places you can get the stems

http://www.pimopipecraft.com/

http://www.jhlowe.com/

http://www.pipemakers.org/

PIMO sells them by the piece, and I think JH Lowe and Pipemakers are by the dozen.

Hope that helps!
David

RadDavis · Post by **RadDavis** » Wed May 17, 2006 9:35 am

Mark Tinsky will probably have what you need:

http://ssl.cybersun.com/scripts/webcata ... 2413~1~101

Rad

MilesW · Post by **MilesW** » Wed May 17, 2006 10:37 am

Thanks for the replies. I will see about a replacement and try to fit it.