For discussion of the drilling and shaping of the stummel.
-
Nick
- Posts: 2171
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/Connecticut
Post
by Nick »
My bits really heated up. Am I pushing to hard?
-
munkey
- Posts: 115
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/California
Post
by munkey »
At what RPM were you drilling?
-
Nick
- Posts: 2171
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/Connecticut
Post
by Nick »
I've since been told that 1750 rpms is just a tad fast for free drilling. D'OOH!
-
KurtHuhn
- Site Admin
- Posts: 5326
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/Rhode Island
Post
by KurtHuhn »
Jeez! I'll say. I normally go 500 - as slow as my lathe will turn. If I could get down to 350 I'd use that speed.
-
ArtGuy
- Posts: 844
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/Indiana
-
Contact:
Post
by ArtGuy »
I do it at around 300. Adam Davidson spins it at 1000 so go figure.