KurtHuhn wrote: To be honest, I never even considered sanding the face of something that is hidden 99.99% of the time.
Neither did I, but I've found that it's one of those things that people look at at a show to determine "quality". I mean, look at this pic:
Doesn't that just scream "Attention To Detail"?
I know it's kind of crazy, but it's what people want to see. And you have to admit, it does look good.
Rad
Oh, no argument that it looks good. You'd have to be a real weirdo to argue that point.
Okay, I'm convinced. It ought to take no time at all to sand it while the stummel is spinning on the lathe. I figure I could a jig similar to the one I made for making shank end caps to make sure it doesn't go out of square.
I square my shank end spinning on a steel rod in my metal lathe after that its just a minutes time on a glass plate with 400 paper and its done..a good tip if its not a very light finish pipe is to stain the shankface black before the sandpaper that will tell you exactly where you are missing out