![Image](http://i133.photobucket.com/albums/q58/randommj/P1030993.jpg)
![Image](http://i133.photobucket.com/albums/q58/randommj/P1030992.jpg)
![Image](http://i133.photobucket.com/albums/q58/randommj/P1030994.jpg)
![Image](http://i133.photobucket.com/albums/q58/randommj/P1030996.jpg)
I have the stem Ill be using, the bowl needs to go a little bit further down, probably another 1/8 in. or so, its sitting at about 1-1 1/8 right now, it could be a little deeper, Ive yet to do an actual measurement yet...I think the easy part is over, now comes the hard part, any tips on the actual shaping, or tips on getting the stem in with a snug fit? Ill be using a drill press for the stem seat, but I just free handed with a dremel tool for what I have to far
input?
Miles