Chucks?
Chucks?
We have an old Shopsmith here and I was wondering if anybody had any 2 or 4 jawed chucks that worked with a Shopsmith that they were wanting to sell? Can't promise I can buy them, the price would have to be right for me, but I thought I'd put the word out. Thanks guys.
"No reserves, no retreats, no regrets"
"When you're dumb...you've got to be tough." - my dad
"When you're dumb...you've got to be tough." - my dad
Re: Chucks?
What is the diameter and thread size of the head stock?
-
- Posts: 417
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Missouri
- Contact:
Re: Chucks?
Best deals are probably used chucks, but I have one I'm using that came from Grizzly tools and while it's not the best, I couldn't beat the price.
The spindle thread size would be needed too figure out if what someone has will fit.
The spindle thread size would be needed too figure out if what someone has will fit.
Pipe Maker in the Making!
-
- Posts: 417
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Missouri
- Contact:
Re: Chucks?
Ok, says it's 5/8" but doesn't say the thread. Penn State sells an adapter to change the thread to 1"x8" which is a pretty common size. Would make it easier to find a used chuck to fit.
http://www.pennstateind.com/store/L5818.html
http://www.pennstateind.com/store/L5818.html
Pipe Maker in the Making!
Re: Chucks?
Thanks guys. I will check on the size and post it then. I appreciate it.
"No reserves, no retreats, no regrets"
"When you're dumb...you've got to be tough." - my dad
"When you're dumb...you've got to be tough." - my dad