That's odd. The one I use isn't setup like that.bscofield wrote:To use a larger draugh hole through the stem? it's quite large is the problem. The original guide pin goes from 1/8" where it's in use guiding the stem to somewhere around a 1/4" where it is held in place. To go larger means to go larger than 1/4".
/me runs out to garage to double check
Yup. It's not. I'ts just a straight 1/8" pin. I dunno, maybe John_V can look at the one I just sent him and check that one. Maybe there's a difference in machining between different batches or something? I did buy ine at two different time, a couple years apart. The one I sent to John_V was never modified, so I didn't take along look at it.