Shop Fox M1016 lathe question
-
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Shop Fox M1016 lathe question
Disregard
Last edited by randyhoguepipes on Sun Sep 07, 2014 6:26 pm, edited 1 time in total.
Re: Shop Fox M1016 lathe question
Having looked for all of ten seconds, your chuck bolts on to the spindle face with three or four bolts correct?
This type of chuck is common C4 'hobby' lathes for example:
http://www.axminster.co.uk/axminster-si ... rod836541/
http://littlemachineshop.com/products/p ... uctID=2338
http://www.grizzly.com/products/5-4-Jaw ... huck/G9834
So as long as the stud size and spacing is the same any make will do.
David
This type of chuck is common C4 'hobby' lathes for example:
http://www.axminster.co.uk/axminster-si ... rod836541/
http://littlemachineshop.com/products/p ... uctID=2338
http://www.grizzly.com/products/5-4-Jaw ... huck/G9834
So as long as the stud size and spacing is the same any make will do.
David
-
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Re: Shop Fox M1016 lathe question
Disregard
Last edited by randyhoguepipes on Sun Sep 07, 2014 6:27 pm, edited 1 time in total.
Re: Shop Fox M1016 lathe question
Since you have a metal lathe and toold already, just make your own blackplate to fit and then use a front mounting chuck.