Good afternoon,
This is the first pipe totally drilled and turned on my new lathe. It is also my first attempt at rustication.
I would like to hear from you guys what you think i should improve or do differently.
Thank you!
Regards,
Bruno
C0213 - Rusticated Poker
-
- Posts: 1346
- Joined: Tue Jan 10, 2012 4:55 pm
- Contact:
Re: C0213 - Rusticated Poker
Pretty dagum decent for sure! I'd say the stem has too much material before the saddle- which is partially an issue of pre-fab stems. As is, I dig it. Just a minor suggestion really.
Re: C0213 - Rusticated Poker
Nicely done. The only suggestion for improvement that I see is that the shank could be a bit longer so the saddle isn't so close in length to the shank. Either that or shorten the length of the saddle about an 1/8".
Re: C0213 - Rusticated Poker
Nice job. Congratulations on the lathe.
Re: C0213 - Rusticated Poker
Thank you for your words guys!
-
- Posts: 41
- Joined: Wed Oct 10, 2012 11:46 am
Re: C0213 - Rusticated Poker
Normally not a fan of the Poker shape, but this one looks, well.... good!
I will agree with my brother on the stem issue.
Do you have any better pictures of the rustication? I like the look of it.
Well done
I will agree with my brother on the stem issue.
Do you have any better pictures of the rustication? I like the look of it.
Well done
Rev says, "holy shit that is bitchen"