I'm about to make a pipes with an offset sadlle like the following ones:
Do you have any idea how it's made? it has some lathe work or it's entirely by hand on a dremel-like tool?
Any pics would help.
Thanks a lot,
Michail
Stem Design
- archaggelosmichail
- Posts: 188
- Joined: Thu Jul 14, 2011 11:11 am
- Location: Paros, Greece
- Contact:
Re: Stem Design
The angled saddle is likely executed like this:
1. Cut the saddle on the lathe
2. Shape the saddle on the disk
3. Finish by hand if necessary
I've been thinking a lot about this myself and this method seems the most likely.
1. Cut the saddle on the lathe
2. Shape the saddle on the disk
3. Finish by hand if necessary
I've been thinking a lot about this myself and this method seems the most likely.
Re: Stem Design
Second pipe done by off-angle turning - chuck the stem "crooked" and face the piece, or similar actions on a drill press, I'm assuming.
ALL YOUR PIPE ARE BELONG TO US!
Re: Stem Design
I'm just guessing, but I think you need to be using delrin tenons in order to accomplish the second one. The first one you can shape by hand.
Rad
Rad
Re: Stem Design
Are you simply referring to the fact that the front and back aren't parallel? Or do you mean the bit is lower than the axis of the shank?
- archaggelosmichail
- Posts: 188
- Joined: Thu Jul 14, 2011 11:11 am
- Location: Paros, Greece
- Contact:
Re: Stem Design
That's it.e Markle wrote:Are you simply referring to the fact that the front and back aren't parallel
Thanks for your ideas, they are helpfull, I think I'm going to do it by hand.
Re: Stem Design
I'm referring to the fact that I can't visualize how one would turn tenon at an angle to slip that inlay over, but I can visualize facing and gluing at a wonky angle and then inserting a tenon afterward.e Markle wrote:Are you simply referring to the fact that the front and back aren't parallel? Or do you mean the bit is lower than the axis of the shank?
Rad
Re: Stem Design
Seems like the only way. I've done it this way before because I couldn't think of different method.RadDavis wrote:I'm referring to the fact that I can't visualize how one would turn tenon at an angle to slip that inlay over, but I can visualize facing and gluing at a wonky angle and then inserting a tenon afterward.e Markle wrote:Are you simply referring to the fact that the front and back aren't parallel? Or do you mean the bit is lower than the axis of the shank?
Rad
Also, Just do it with files or a dremel, it's not much harder than cutting a normal saddle.
J&J Pipes
jnjpipes.com
jnjpipes.com