I've sharpened, honed and re-sharpened the cutter. I've made sure the cutter is not too low or too high regarding the rodstock. I've made sure that the carriage does not have any play. All I can think of at the moment, is that there is a problem with the feed. But why now only, after all these years of doing it without any problem?
Any of you tool-clever guys have an idea or help?
The lathe is a Myford ML7 and the tenon on the photo has had a rough cut, to show the diagonal lines better.
![Image](http://i255.photobucket.com/albums/hh140/charlchillfactor/WP_20141211_002.jpg)