My lathe has the following speeds available:
875
1350
2250
3450
I have only used it at 875, and I find that speed makes a shaping disc turn at a speed that is fast enough to do the job without taking more off than I intended.
What speed should I use for actually turning a pipe block? I've had a scrap one chucked into my Nova G3 and it didn't vibrate or jump around at 875, but I really don't remember anything about what speeds to do what on a lathe so I'm asking you all for advice.
A question of speed
A question of speed
I hope to be at least half the person my dogs thinks I am.
AKA Terry
AKA Terry
Re: A question of speed
Use the speed that is comfortable for you and works. There is no set speed for turning or drilling as it will vary according to the lathe, the tools and the user. If 875 works for you, use it.
- KurtHuhn
- Site Admin
- Posts: 5326
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: United States/Rhode Island
Re: A question of speed
What Chris said - because the blocks are mounted off-center and can vibrate the crap out of your lathe, use what you're comfortable with and what the lathe can handle.
Re: A question of speed
In regard to a wood lathe, in my _very_ limited experience I have found between 800-1000 is my comfort zone. Being cautious I started out at slower speeds as low as 500 and found that to be actually more difficult.
Re: A question of speed
I find that once you turn the shank, you can actually turn the bowl at max speed because there's almost zero wobble. That being said, I've mounted my lathe to my bench, so use caution your first time at higher speeds.
“Tools don’t make pipes” -SandahlPipe
“Every Pipe is a Billiard” -SandahlPipe
"Plan your work, work your plan" -Walt Cannoy
“Every Pipe is a Billiard” -SandahlPipe
"Plan your work, work your plan" -Walt Cannoy