Just finished this for the next catalog update:
Passes a cleaner straight down into the bowl. AND, the mortise had to be only 1/4" in order to keep the shank narrow and light, so there wasn't much room to tilt the airhole bit, but it can be reamed with a bit still. No ramping done, either - instead, I managed it by moving the tenon inlet.
Speaking of drilling challenges
Speaking of drilling challenges
Happy Smoking,
Trever Talbert
www.talbertpipes.com
My Pipe Blog:
https://talbertpipes.com/category/pipeblog/
My Lizards & Pipes Web Comic:
https://talbertpipes.com/category/lizards/
Trever Talbert
www.talbertpipes.com
My Pipe Blog:
https://talbertpipes.com/category/pipeblog/
My Lizards & Pipes Web Comic:
https://talbertpipes.com/category/lizards/