Assuming a 2.5" long shank on a liverpool (total length
of shank and bowl 4") what should the diameter of the
shank be?
Thanks
Shank diameter for a Liverpool
These show a reasonable approximation of ratio: http://www.aspipes.org/shapes/canadfam.html
Regards,
Frank.
------------------
Grouch Happens!
People usually get the gods they deserve - Terry Pratchett
Frank.
------------------
Grouch Happens!
People usually get the gods they deserve - Terry Pratchett
Thanks! Without thinking much I made one with a 5/8 shank
for a sterling silver band I had. I was also using walnut since I
think that looks good with a silver band. In any case, after
I finished I noticed that Liverpools usually have narrower
shanks for that size. I stuck a picture of it in the avatar, but
not much is visible -- but you can see the thicker shank!
I liked this one.
for a sterling silver band I had. I was also using walnut since I
think that looks good with a silver band. In any case, after
I finished I noticed that Liverpools usually have narrower
shanks for that size. I stuck a picture of it in the avatar, but
not much is visible -- but you can see the thicker shank!
I liked this one.