Learning from my mistakes
Posted: Thu Dec 17, 2009 10:18 am
Learning I can't try aggressive angles on pre-boared blocks. Ahhhhhhh (also check out my sweet pink compass)
pipemakersforum.com
The original forum for pipe makers on the web
http://www.pipemakersforum.com/forum/
Learning from my mistakes
Page 1 of 1
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 10:40 am
Bummer!
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 11:50 am
Ack thats not fun... 
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 12:25 pm
Man, I NEVER did anything like that when I started out... 
Also, I have never cracked a shank, mis-drilled a draught hole, or cut a tenon to thin. My crap also smells like roses and fuzzy white bunnies follow me everywhere I go.
Also, I have never cracked a shank, mis-drilled a draught hole, or cut a tenon to thin. My crap also smells like roses and fuzzy white bunnies follow me everywhere I go.
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 2:08 pm
Pipes with three holes are bad.
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 2:30 pm
Hmmmmm.... 
I usually break through on the bottom, not the side!
I usually break through on the bottom, not the side!
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 4:28 pm
It could be worse, i.e., mistakes from your learning.
M.M.
M.M.
Re: Learning from my mistakes
Posted: Thu Dec 17, 2009 7:08 pm
I was thinking about bedazzling it. Putting a giant ruby right in the middle and selling it at Nordstroms!