New drill press, some questions
Posted: Sun Aug 08, 2010 3:40 pm
This is the drill press I found on craigslist this weekend. It needed a little work, but it's fully functional now. Good score for fifty bucks I'd say.
![Image](http://i840.photobucket.com/albums/zz328/msheppard666/dscn0250resized.jpg)
My question is about drilling speed. 600 rpm is the lowest speed possible as it's set up right now. Do I need to rig up a third pulley to slow it down or will this work. What speeds do you guys drill different materials at (ebonite,Lucite,delrin,briar) so I have an idea of how slow I should get this thing if I do need to slow it down
thanks
michael
![Image](http://i840.photobucket.com/albums/zz328/msheppard666/dscn0250resized.jpg)
My question is about drilling speed. 600 rpm is the lowest speed possible as it's set up right now. Do I need to rig up a third pulley to slow it down or will this work. What speeds do you guys drill different materials at (ebonite,Lucite,delrin,briar) so I have an idea of how slow I should get this thing if I do need to slow it down
thanks
michael