Page 1 of 1
logo's Stamps
Posted: Wed May 18, 2011 12:29 pm
by giospro
Where can you go to get a customs stamp done with your logo on it? or do you have to have an lazer/engraver? to do logo's on pipes?
which is easier?
Never done this but like to start doing it on my pipes.
Re: logo's Stamps
Posted: Wed May 18, 2011 12:42 pm
by taharris
Re: logo's Stamps
Posted: Wed May 18, 2011 1:45 pm
by baweaverpipes
giospro wrote:Where can you go to get a customs stamp done with your logo on it? or do you have to have an lazer/engraver? to do logo's on pipes?
which is easier?
Never done this but like to start doing it on my pipes.
Most anything you are looking for can be answered by searching this forum.
You were very lucky not to be raked over the coals by asking something that has been covered many times.
Search the forum and don't be so lazy in the future.
Not trying to be an ass, but simply keeping you from harms way. At least you're not a ignorant as Simon Tucker.
Re: logo's Stamps
Posted: Wed May 18, 2011 1:51 pm
by giospro
Thanks
Re: logo's Stamps
Posted: Thu May 19, 2011 8:56 pm
by Mike Messer
baweaverpipes wrote: ... Not trying to be an ass...
Were too.
Re: logo's Stamps
Posted: Thu May 19, 2011 9:13 pm
by Mike Messer
I just ran through the suggested thread, maybe I missed it? but I didn't see it....
Best In The Business...Paul Argendorf, A&M Steel Stamps...
amsteelstamps@yahoo.com
A&M Steel Stamps, Inc.
55 Windsor Ave.
Mineola, LI, NY 11501
516-741-6223
The Stamps are precision machined in hardened tool steel and must be sharp to work well.
A&M knows how to make them right. Just tell them you want a hand stamp to stamp handmade tobacco pipes, the design, send images, etc., and they will give you a price quote.
Re: logo's Stamps
Posted: Fri May 20, 2011 3:23 pm
by SimeonTurner
baweaverpipes wrote: At least you're not a ignorant as Simon Tucker.
I hate that guy!