Make a stem without a lathe
Posted: Mon Nov 19, 2012 7:20 pm
Hello everyone,
This forum is amazing.. Is it posible to make a stem avoiding the lathe? I have a drill press (and the pimo tool), can i use it for the drilling process, and to acomplish the whole work of the stem that needed to be done ? If yes what is the procedure and where can i buy ebonite rods for a good price in europe because i am from Greece?
Thank you in advance
This forum is amazing.. Is it posible to make a stem avoiding the lathe? I have a drill press (and the pimo tool), can i use it for the drilling process, and to acomplish the whole work of the stem that needed to be done ? If yes what is the procedure and where can i buy ebonite rods for a good price in europe because i am from Greece?
Thank you in advance