Clamping an unusual angle...

[WCannoy]

My benchtop drill press doesn't see much action anymore, but with the help of a bungee, comes in handy when I need to clamp an unusual angle while the glue dries!

[d.huber]

Lol! That is so ghetto it's brilliant!

[WCannoy]

Lol! That is so ghetto it's brilliant!

I'm all about the ghetto shop method! You have no idea! I'm O.G.!

[Sasquatch]

That... might make it on White Trash Repairs. com

[AlfaDog]

Surgical tubing stretched around unusual shapes makes a good clamp also. Love the bungee press, too.

[Massis]

why the bungee? can't you apply enough pressure by just rising your table high enough untill it hits the chuck?

[wmolaw]

why the bungee? can't you apply enough pressure by just rising your table high enough untill it hits the chuck?

Glad someone asked this question! I usually use my lathe for this, which is why I'm considering buying another of the Rikons.

[WCannoy]

why the bungee? can't you apply enough pressure by just rising your table high enough untill it hits the chuck?

This particular table does not crank up and down. It's either locked or unlocked, and when it is unlocked you raise and lower it by working it back and forth to try to coax it to move! In the absence of the crank, seems a bungee was a good way to keep positive pressure on the joint as it cures.

[WCannoy]

Surgical tubing stretched around unusual shapes makes a good clamp also.

Yeah, but I'd have to go out and buy some of that. I already have the drill press and bungee...

[WCannoy]

Glad someone asked this question! I usually use my lathe for this, which is why I'm considering buying another of the Rikons.

I could just as well use the lathe, but that would tie it up for a while and I certainly would need to use it for something else. This drill press is rarely used, so I can spare it for clamping duty for a few hours if needed...

[pipeguy]

Walt, What r u gluing in place???? more pics

[WCannoy]

Walt, What r u gluing in place???? more pics

It's a paneled freehand. It's gonna get mostly blasted...

[WCannoy]

The sliver of ebonite on the bottom will be the last thing to be done as I want to balance it to sit perfectly!

[the rev]

that is a beauty

rev

[Duane]

Wow! That's Beautiful!.......But, will it shoot a poison dart?

Duane

[d.huber]

Walt, how do you go about facing an angle on your work pieces?

[WCannoy]

Wow! That's Beautiful!.......But, will it shoot a poison dart?

Psshhh... No.
But it has a secret compartment that opens up to reveal a Gatling Gun...

But that reminds me: I once made a Poison Dart Frog...

[WCannoy]

Walt, how do you go about facing an angle on your work pieces?

I flatten it to about where I want it by hand with a hard backed sanding disc, then fine tune it by dragging it across a piece of 220 laid flat on a smooth surface (I use a small piece of glass)...

[d.huber]

Walt, how do you go about facing an angle on your work pieces?

I flatten it to about where I want it by hand with a hard backed sanding disc, then fine tune it by dragging it across a piece of 220 laid flat on a smooth surface (I use a small piece of glass)...

Sweet. Thanks!

[WCannoy]

Sometimes and angled joint looks ok...




Sometimes it doesn't look so ok...