pipemakersforum.com

...but maybe one of you guys might jump on it.

http://lexington.craigslist.org/tls/3598429637.html

Jet 9x20 with a few extras. $800 near Lexington, KY.

For what it's worth...

Looks like a good deal to me. Just like the one I have and is already set up with the QCTP. hope someone is close enough to snap this one up.

if that wouldn't cost me 500 dollars to ship to Long Beach Cali I would be all over that

rev

Rev I'm surprised in a town like Long beach with all those ports and trade shops along there that you can't find somthing " ON THE WATERFRONT"

Long Beach and San Pedro ports, the valley, we even have the damn city of industry. I have been searching in Orange County, LA county, Riverside and San Bernardino Counties and Ventura county... only lathes that seem readily available are either too small, or absolutely huge and expensive.

rev

Used to live in Mission Viejo/Irvine... everything is expensive. Glad I got out. Especially now that I hear your lathe searching woes.

And it's......GONE!!!!

You?

Naw, Nate just uses a 5 axis milling machine for all his stuff.

I have a PM1127VF-LB. Has an AXA QCTP. Works well. The one the rev found is pretty sweet, South Bend made good lathes. I learned on a war-surplus 1940's South Bend lathe. If I had the extra cash and could get the lathe shipped, I'd buy it myself.

Nate wrote:I have a PM1127VF-LB. Has an AXA QCTP. Works well. The one the rev found is pretty sweet, South Bend made good lathes. I learned on a war-surplus 1940's South Bend lathe. If I had the extra cash and could get the lathe shipped, I'd buy it myself.

You just jargon'd me in the face.