Extra parts
Posted: Wed Mar 06, 2013 11:08 am
Anyone know how much a steady rest and follow rest for a Jet BD920N should sell for? I have both and am looking to sell them. I can't find anything on ebay or google.
pipemakersforum.com
The original forum for pipe makers on the web
http://www.pipemakersforum.com/forum/
Extra parts
Page 1 of 1
Re: Extra parts
Posted: Wed Mar 06, 2013 12:31 pm
Yes, hope this helps
Re: Extra parts
Posted: Wed Mar 06, 2013 1:20 pm
You dawg.
Re: Extra parts
Posted: Wed Mar 06, 2013 2:48 pm
Probably not a lot considering the lathe is widely available. If it were me I would hang on to them, might come in handy one day and would make re-sell easier in the future.
Re: Extra parts
Posted: Wed Mar 06, 2013 4:20 pm
But I want to have money now... 
So I can buy more briar... and more tooling... and and and...
So I can buy more briar... and more tooling... and and and...
Re: Extra parts
Posted: Wed Mar 06, 2013 6:49 pm
Welcome to pipemaking rob Peter to pay Paul this is the story of everyone's life.
Except for prodegies like Rad then everything comes to you for free
Except for prodegies like Rad then everything comes to you for free
Re: Extra parts
Posted: Thu Mar 07, 2013 2:09 pm
Hang on to 'em. You'll need them when you need to make a churchwarden stem one of these days. You'll curse them until you figure out how much pressure to use, but they (particularly the follower rest) are very helpful for turning long noodly bits and keeping them centered.