Page 1 of 1
Ken Lamb chuck - SOLD
Posted: Sat Dec 07, 2013 6:31 pm
by buster
I have a Ken Lamb drilling alignment chuck for sale. It is about 5 months old and I say I've used it less than 15 times. Accepting reasonable offers. PM me if interested. Thanks.
Re: Ken Lamb chuck
Posted: Sat Dec 07, 2013 8:19 pm
by Tyler
buster wrote:I have a Ken Lamb drilling alignment chuck for sale. It is about 5 months old and I say I've used it less than 15 times. Accepting reasonable offers. PM me if interested. Thanks.
Pics?
How do you mount it to the lathe?
Re: Ken Lamb chuck
Posted: Sat Dec 07, 2013 9:19 pm
by buster
It has a large tenon on it to mount in your chuck.
http://www.lambpipes.com/pipemakingtools.htm
Re: Ken Lamb chuck
Posted: Sat Dec 07, 2013 11:04 pm
by Tyler
Ah, got it.
Ken's had about 5 or 6 designs through the years. I haven't kept up. I should have thought to go check the site for the latest since this is a relatively new chuck. I also didn't know he was exclusively on the three-jaw tenon design now.
Thanks.
This is interesting to me, but I don't have the cash right now. I'll watch to see if it hangs around.
Re: Ken Lamb chuck
Posted: Sun Dec 08, 2013 10:38 am
by buster
Ok. Thanks.