Hi all,
Just looking for some rod. I'd prefer vulcanite, but lucite is fine too. I don't need that much, as all I'm making at the moment is three or four Canadians.
Thanks
NJ
WTB rod
Try www.pipemakers.org. I purchased some lucite rod stock from them in the past. It runs about $10 for 18". Plus, if you're not using a lathe, the stuff is squared off so that you could put it in a vise for a press.
Jeff
Jeff
Ben,
That is their price for ebonite rod stock. I've purchased this through them as well. Their pricing for Lucite is around $10/pp though. I'm assuming that Nick doesn't want to drop the cash on 2 rods, so lucite will probably be the best bet. Actually, I believe that pipemakers.org is out of vulcanite anyway.
Best,
Jeff
That is their price for ebonite rod stock. I've purchased this through them as well. Their pricing for Lucite is around $10/pp though. I'm assuming that Nick doesn't want to drop the cash on 2 rods, so lucite will probably be the best bet. Actually, I believe that pipemakers.org is out of vulcanite anyway.
Best,
Jeff