I tried to experiment with some bamboo on some pieces of briar that I had previously ruined (not hard in my case). The bottom of the pipe I cracked the bamboo on the briar and stem side. I know I should be using like a 6mm steel tubing, but I have been a bit slow (lazy?) on getting around to buy some. I used 8mm delrin and I am pretty sure it is just too big. Other than that, I was hoping some of you more experienced gents ( and scottie) might be able to point me in the right direction.
1st - When I am sanding this down to make a smooth transition I found that I also sanded part of the bamboo away. I just am assuming that I was rushing a bit and not being careful, but I saw in an earlier post that Mr. Weaver doesn't put a ring between bamboo and briar and I wanted to know what is a good method for making that smooth transition without damaging or scratching the bamboo.
2nd - While buffing the transition area it took off more of the stain around the shank. How do you get a nice even buff and color when the briar takes on the wrinkly shape of the bamboo?
I hope these seem like legitimate questions and I am not wasting anybody's time...
Here are some pictures of my experiment:
biffing with bamboo
biffing with bamboo
- Attachments
-
- 3.jpg (9.74 KiB) Viewed 2238 times
-
- 2.jpg (23.67 KiB) Viewed 2238 times
-
- 1.jpg (20.15 KiB) Viewed 2238 times
Re: biffing with bamboo
Sorry guys, I think I was a little to anxious to get this posted. I have searched some of the older threads and I am pretty sure I found my answer.
Re: biffing with bamboo
You don't have to put a spacer between the bamboo and stummel. It's just harder not to. Takes more skill to go without the spacer .
andrew
andrew
Andrew
www.andrewstaplespipes.com
www.andrewstaplespipes.com
Re: biffing with bamboo
Thanks! I will try that on the next one. I often find myself getting quite anxious when a pipe is starting to take shape and that is where I am making most of my mistakes. The pipes you have in your gallery have become a bit of a motivation for me. Appreciate your post!