Beall Collet Holder
15/16" Collet (ER32M)
Less than one year old
Thread: 3\4x 16 tpi (fits a Taig lathe)
Beall Collet Holder w/15/16" Collet (SOLD)
-
randyhoguepipes
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Beall Collet Holder w/15/16" Collet (SOLD)
Last edited by randyhoguepipes on Fri May 15, 2015 10:54 pm, edited 3 times in total.
-
Jthompson1995
- Posts: 186
- Joined: Sat Apr 13, 2013 6:32 am
- Location: Parkville, MD
Re: Beall Collet Holder w/15/16" Collet (REDUCED) - $45
What thread size is this? If it's 1"x8 tpi I'll take it.
Anybody can become a woodworker, but only a Craftsmen can hide his mistakes!
-Walter Blodget
-Walter Blodget
-
randyhoguepipes
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Re: Beall Collet Holder w/15/16" Collet (REDUCED) - $45
Thread size is 3/4 x 16 tpi (fits a Taig lathe). Thanks for looking.Jthompson1995 wrote:What thread size is this? If it's 1"x8 tpi I'll take it.
-
dogcatcher
- Posts: 163
- Joined: Thu Feb 14, 2013 2:40 am
- Location: Abilene TX or Ruidoso NM
Re: Beall Collet Holder w/15/16" Collet (REDUCED) - $45
I will take it, message sent with my info.
-
randyhoguepipes
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Re: Beall Collet Holder w/15/16" Collet (SOLD)
Item has been SOLD. Thanks.
-
randyhoguepipes
- Posts: 40
- Joined: Thu Feb 24, 2011 5:44 pm
- Location: Canton, GA
Re: Beall Collet Holder w/15/16" Collet (SOLD)
Item has been sold. Thanks.
Randy
Randy