Buffing plateaux?

Sanding, rusticating, sandblasting, buffing, etc. All here.
Post Reply
Pkspecial23
Posts: 17
Joined: Thu Mar 30, 2017 6:31 pm

Buffing plateaux?

Post by Pkspecial23 »

Hey guys,
In general, when finishing a freehand, how do you properly finish the plateaux section around the bowl and/or mortise? Should I stain? Do I use the regular buffing process or is there some special way of doing it? Thanks fellas.
User avatar
sandahlpipe
Posts: 2106
Joined: Mon Feb 04, 2013 8:49 pm
Location: Zimmerman, MN
Contact:

Re: Buffing plateaux?

Post by sandahlpipe »

Stain and seal with shellac. Don't buff. Or you can try a more difficult way and buff.
---
Fail early, fail often. Your success depends on it.

Jeremiah Sandahl
http://sandahlpipe.com
wdteipen
Posts: 2819
Joined: Sat Mar 29, 2008 1:05 pm

Re: Buffing plateaux?

Post by wdteipen »

I'm assuming you've removed all the bark. If not, you have to remove all the bark. The easiest way is to sandblast it off. A stiff nylon bristle brush will take it off with elbow grease. A dental pick works for stubborn pieces. I finish plateaux the same way I finish any other part of the pipe except it's not necessary to buff with tripoli. Stain, shellac, then wax. If the wax builds up, heat it with a heat gun then rebuff.
Wayne Teipen
Teipen Handmade Briar Pipes
http://www.teipenpipes.com
Pkspecial23
Posts: 17
Joined: Thu Mar 30, 2017 6:31 pm

Re: Buffing plateaux?

Post by Pkspecial23 »

Got it. Thank you sirs.
Pkspecial23
Posts: 17
Joined: Thu Mar 30, 2017 6:31 pm

Re: Buffing plateaux?

Post by Pkspecial23 »

Also, can I just use run of the mill shellac from Home Depot? Or do I need something specialized?
User avatar
sandahlpipe
Posts: 2106
Joined: Mon Feb 04, 2013 8:49 pm
Location: Zimmerman, MN
Contact:

Re: Buffing plateaux?

Post by sandahlpipe »

Yes. Bullesye shellac works fine. You can add denatured alcohol to thin it out.
---
Fail early, fail often. Your success depends on it.

Jeremiah Sandahl
http://sandahlpipe.com
Pkspecial23
Posts: 17
Joined: Thu Mar 30, 2017 6:31 pm

Re: Buffing plateaux?

Post by Pkspecial23 »

Thank you!
Post Reply