Pipemaker Tooling

[FredS]

Any word yet on when this is going down? Because it sounds amazing

Spoke with Todd briefly at the show, he said some of it is still at the tool & die shop. Should be coming soon though I believe. I bet he'll give us an update on it soon.

I spent 18 years working in tool & die shops. Expect them to be three months late.

[Mike Messer]

I would truly like to see Todd's custom tooling site. I'm sure it will be good, I mean, if he ever gets around to doing it.
Meanwhile if you need a custom chuck, or an S&D chamber bit at reasonable prices check out Trent Rudat's web site: http://www.briarpipetooling.com/
Some examples:
...

[tigercasual]

Any News?

[Archer]

I am interested in this as well. Would be nice to see affordable in this craft!

[Joe Hinkle Pipes]

It has been a while since this was first posted. any updates on the new tool designs?

[Bobostro61]

Last post for this was on Feb. 2 2012, is Todd's web site up yet? I could use a good sanding wheel instead
of the cheap plastic stuff from Menards.

[ToddJohnson]

You can count on the fact that by 2050 it will either be up, or not.

TJ

[e Markle]

The Tautologist strikes again.

-Beefcake

[wdteipen]

Mr. Johnson is just a tease. A cruel, cruel tease.