Page 2 of 2
Re: Pipemaker Tooling
Posted: Tue May 31, 2011 5:04 pm
by FredS
Nate wrote:ReddishMoon wrote:Any word yet on when this is going down? Because it sounds amazing
Spoke with Todd briefly at the show, he said some of it is still at the tool & die shop. Should be coming soon though I believe. I bet he'll give us an update on it soon.
I spent 18 years working in tool & die shops. Expect them to be three months late.
Re: Pipemaker Tooling
Posted: Wed Jun 01, 2011 2:39 am
by Mike Messer
I would truly like to see Todd's custom tooling site. I'm sure it will be good, I mean, if he ever gets around to doing it.
Meanwhile if you need a custom chuck, or an S&D chamber bit at reasonable prices check out Trent Rudat's web site:
http://www.briarpipetooling.com/
Some examples:
...
Re: Pipemaker Tooling
Posted: Tue Nov 01, 2011 12:33 am
by tigercasual
Any News?
Re: Pipemaker Tooling
Posted: Tue Nov 01, 2011 1:16 pm
by Archer
I am interested in this as well. Would be nice to see affordable in this craft!
Re: Pipemaker Tooling
Posted: Thu Feb 02, 2012 7:41 pm
by Joe Hinkle Pipes
It has been a while since this was first posted. any updates on the new tool designs?
Re: Pipemaker Tooling
Posted: Fri Dec 14, 2012 8:10 am
by Bobostro61
Last post for this was on Feb. 2 2012, is Todd's web site up yet? I could use a good sanding wheel instead
of the cheap plastic stuff from Menards.
Re: Pipemaker Tooling
Posted: Thu Jan 31, 2013 6:35 pm
by ToddJohnson
You can count on the fact that by 2050 it will either be up, or not.
TJ
Re: Pipemaker Tooling
Posted: Thu Jan 31, 2013 7:39 pm
by e Markle
The Tautologist strikes again.
-Beefcake
Re: Pipemaker Tooling
Posted: Fri Feb 01, 2013 9:32 pm
by wdteipen
Mr. Johnson is just a tease. A cruel, cruel tease.