#10. The Author
Posted: Sat Jun 20, 2020 1:31 am
Here is my best work yet:
pipemakersforum.com
The original forum for pipe makers on the web
https://www.pipemakersforum.com/forum/
#10. The Author
Page 1 of 1
Re: #10. The Author
Posted: Mon Aug 24, 2020 10:44 pm
Fantastic!
Re: #10. The Author
Posted: Thu Sep 10, 2020 9:26 pm
Very nice!Re: #10. The Author
Posted: Fri Sep 11, 2020 9:36 am
Good work!
Re: #10. The Author
Posted: Sun Sep 13, 2020 8:45 pm
Fit and finish look nice. The shank appears to have a slight reverse taper. It's possible that it's an optical illusion caused by not tapering it at all. You should taper it by at least a degree or so. I'd also add a curve to the shank so the shape flows a bit more. Straight shanks on bent pipes tend to look a bit jarring. Otherwise, well done!