Hi,
is there an easy way to glue an accent ring on the shoulder I turned onto the end of the shank, but only temporarily?
That way I can finish the ring, take it off, finish (sandblast, dye etc.) the stumble and glue the ring on permanently.
Something like locktite that can be dissolved with heat or the likes?
Thanks!
Accent rings - glued on temporarily?
-
- Posts: 23
- Joined: Tue May 11, 2021 4:45 am
- Contact:
Re: Accent rings - glued on temporarily?
You use a couple of tiny dots of CA applied with a toothpick, then you can break it off.
-
- Posts: 3124
- Joined: Sun Sep 02, 2007 4:29 am
- Location: Kansas City, USA
- Contact:
Re: Accent rings - glued on temporarily?
CA has a low tolerance for heat. The recipes vary some, but most soften significantly around the boiling point of water.
Takeaway? Do what Chris suggests, and if you have trouble popping the ring off without worring about damage hit it with a heat gun.
Takeaway? Do what Chris suggests, and if you have trouble popping the ring off without worring about damage hit it with a heat gun.
UFOs must be real. There's no other explanation for cats.
-
- Posts: 23
- Joined: Tue May 11, 2021 4:45 am
- Contact:
Re: Accent rings - glued on temporarily?
Excellent! Dankeschön - as always.