Second Attempt At An Acrylic Stem

Want to show you work to the world? Want a place to post photos of your work and solicit the opinions of those that have gone before you? Post your work here.
Post Reply
shikano53
Posts: 267
Joined: Sat Jun 18, 2016 10:50 am

Second Attempt At An Acrylic Stem

Post by shikano53 »

I would welcome any comments or suggestions on this pipe with my 2nd attempt at making an acrylic stem. I rusticated this one because of a few cosmetic pits. Would appreciate help and suggestions on the stem. I cut the slot with my Dremel 199? bit and then took Jeremiah's advice and used a 1/16" bit instead of a 5/64" bit to widen and shape the slot.
Thanks guys and gals.
Image
Image
Image
Image
User avatar
sandahlpipe
Posts: 2106
Joined: Mon Feb 04, 2013 8:49 pm
Location: Zimmerman, MN
Contact:

Re: Second Attempt At An Acrylic Stem

Post by sandahlpipe »

The slot doesn't look too bad. You'd want to round the slot on the inside. You can use sandpaper or you can get a round needle file and then sandpaper. The other thing to work on is keeping straight lines on your stem.
---
Fail early, fail often. Your success depends on it.

Jeremiah Sandahl
http://sandahlpipe.com
shikano53
Posts: 267
Joined: Sat Jun 18, 2016 10:50 am

Re: Second Attempt At An Acrylic Stem

Post by shikano53 »

Thanks Jeremiah. I have a couple of small, thin Kemper files I got from VFH. Are those the types of file you are referring to? I'm thinking that if I get a Popsicle stick kind of piece of wood but thinner, and glue sand paper to it would work?
User avatar
sandahlpipe
Posts: 2106
Joined: Mon Feb 04, 2013 8:49 pm
Location: Zimmerman, MN
Contact:

Re: Second Attempt At An Acrylic Stem

Post by sandahlpipe »

I got a #4 cut needle file. It's different. I use the Kemper to open the slot, but then the file to smooth the edges afterwards. You could also fold sandpaper if you wanted. I don't think you'll get a piece of wood thin enough and sturdy enough to fold sandpaper around.
---
Fail early, fail often. Your success depends on it.

Jeremiah Sandahl
http://sandahlpipe.com
DocAitch
Posts: 1113
Joined: Mon Dec 14, 2015 12:44 am
Location: Baltimore, Maryland

Re: Second Attempt At An Acrylic Stem

Post by DocAitch »

I use a piece of hacksaw blade ground to the shape I want, then glue various grits of paper to it with CA glue. When I want to change paper, I burn off the paper and glue (outside and up wind, this smells pretty toxic), wipe off the ashes, and glue new paper on. If you round the back of the blade, the sandpaper can be glued in a U shape so that you have two flat sides and a round surface for the corners of the slot. These fit fine in a 1/16” slot.
I also put a little handle on the sander with thermomalleable plastic.
DocAitch
"Hettinger, if you stamp 'hand made' on a dog turd, some one will buy it."
-Charles Hollyday, pipe maker, reluctant mentor, and curmudgeon
" Never show an idiot an unfinished pipe!"- same guy
Post Reply