I bought the lathe, at last! ! !
-
S. Vyzhanov
- Posts: 24
- Joined: Fri Jan 17, 2014 12:21 pm
- Location: Екатеринбург. Россия
- Contact:
I bought the lathe, at last! ! !
I want to boast! I bought the lathe! Now I started a new pipe on the new equipment. It is necessary studies anew. I did all pipes only by means of a drill and the motor for a stone earlier.
-
pipedreamer
- Posts: 1056
- Joined: Mon Jan 07, 2013 6:25 pm
Re: I bought the lathe, at last! ! !
Good for you! Enjoy!
Re: I bought the lathe, at last! ! !
Congrats! That lathe is going to change everything. Enjoy!
-
Tyler
- Site Supporter
- Posts: 2376
- Joined: Thu Nov 23, 2006 8:00 pm
- Location: Farmersville, TX
- Contact:
Re: I bought the lathe, at last! ! !
Awesome, congrats!
Tyler Lane Pipes
http://www.tylerlanepipes.com
http://www.tylerlanepipes.com
Re: I bought the lathe, at last! ! !
How many pipes did you make before you bought the lathe? I'm just starting out and expect it will be a few years if I stick with it.
What's the lathe sitting on, a concrete pad or blocks?
What's the lathe sitting on, a concrete pad or blocks?
Bob
Re: I bought the lathe, at last! ! !
You gonna use it for stems? Congrats!
-
S. Vyzhanov
- Posts: 24
- Joined: Fri Jan 17, 2014 12:21 pm
- Location: Екатеринбург. Россия
- Contact:
Re: I bought the lathe, at last! ! !
Thanks for congratulations!
Without machine I made about 40 - 50 pipes. I want to use it for stalks and block drilling, with spindle replacement. I made such adaptation, I hope will help:
Without machine I made about 40 - 50 pipes. I want to use it for stalks and block drilling, with spindle replacement. I made such adaptation, I hope will help:
