They are in! I have it straight from Oneway that the Talon jaws will fit the standard Oneway scroll chuck. I just ordered a set of the #2 profiled Jaws from the Oneway site.
55 bucks and change shipped to my door! Man I am stoked.
They are available now!!! Great! I've been looking forward to these jaws since they came out with them for the stronhold. There goes my vow not to buy any more equipment this month!
Hey John, since you only use two of the jaws, would you send me the other two????????? Just kidding!
All ya need to do to make them perfect is drill a 1/4 inch hole 3/8 of an inch down from the top (centered in the jaws) and tap it for a 1/4x20tpi screw. Turn down a point on the 2 screws and you'll have a great way to handle the drillings!
John and others, are you going to tap the new jaws or keep them as is? If as-is, do you rely completely on a square block and selft centering system to get a straight drilling?
I make certain the block is square. With the self centering chuck, as long as the block is square you will get a straight drill. There may not be quite enough clearance with these jaws to put screws in and rotate the block clear around in the chuck.
Yes, I am interested. What I had planned, was that I would just order a set, and post the two jaws on this forum for half of the cost plus shipping. If that works for you, I will let you know when I receive them. If you are still interested at the time, your welcome to them. I have a PayPal account that I can receive payment, including credit card payments.